Installation of water meter
Installation of water meter is a plumber. This assembly is normally performed at the moment of putting into operation a new home. It must be remembered that after sealing the counter, you can not carry out any repairs yourself, because we can be accused of is that we were trying to cheat on the amount of water consumed by us, thus reducing the incoming letter bills. Such a meter reading is a worker employed by a company supplying us water. But reading the meter of water is so simple that we can also ourselves through his regular reading to control the amount of water consumed by us. Sometimes it may happen that the water meter sours after many years of its use. Replacement of such counter will plumber.
Sometimes we notice that arose in our house a problem with water pressure. At too low water pressure it flows from the tap a little trickle and practically we are not able to use it. However, at too high pressure water can even damage the hose leading it, for example, the washing machine and help to create failure of the entire device. It can also cause the hose pops out with security and water will flood our bathroom. Therefore, such a problem immediately turn to a plumber. Another problem associated with the use of water in the home can be adjust the temperature when the tap is flying too hot or cold water constantly. You may then find that the repair will require owned by us boiler. Sometimes you will even replace the boiler with a new one.
Materials for plumbing
Water systems of ancient times relied on gravity for the supply of water, using pipes or channels usually made of clay, lead, bamboo, wood, or stone. Hollowed wooden logs wrapped in steel banding were used for plumbing pipes, particularly water mains. Logs were used for water distribution in England close to 500 years ago. US cities began using hollowed logs in the late 1700s through the 1800s.8 Today, most plumbing supply pipe is made out of steel, copper, and plastic; most waste (also known as "soil") out of steel, copper, plastic, and cast iron.
The straight sections of plumbing systems are called "pipes" or "tubes". A pipe is typically formed via casting or welding, whereas a tube is made through extrusion. Pipe normally has thicker walls and may be threaded or welded, while tubing is thinner-walled and requires special joining techniques such as brazing, compression fitting, crimping, or for plastics, solvent welding. These joining techniques are discussed in more detail in the piping and plumbing fittings article.